Custom RV Dinette & Bench Seat Replacement Vinyl Cover

Your RV deserves better than cracked, peeling seats.

A professional reupholstery job runs $300–$600. A new cushion set? Even more. Our custom-made vinyl replacement cover gives you a factory-fresh look for a fraction of the cost — and you can do it yourself in under 30 minutes.

⚠️ Custom Quote Required — Not a Standard Add-to-Cart Item

Because every RV seat is different, we review each order individually before confirming. Do not purchase without contacting us first. Here's how it works:

1. Send us your measurements — Length × Width × Thickness of your cushion
2. Send us photos — top, bottom, and all four sides of your existing cushion
3. We review your request — we confirm we can produce your cover and send you a custom quote
4. You approve — we build it — made to your exact specs once confirmed

👉 Click here to submit your measurements and photos for a quote

Built for Your Exact RV

No two RVs are exactly alike. That's why we make every cover to your exact measurements — not close, not approximate. Your dimensions. Your cover.

• RV Dinette Seat Bottom Cover
• RV Dinette Back Cushion Cover
• RV Bench Seat Cover

Works with RVs, campers, motorhomes, fifth wheels, and travel trailers.

Important: Wood Base Required

This is a staple-on cover — not a slip cover or box cushion cover. Your cushion must have a wood or plywood base to staple to. This applies to seat bottoms AND backrests. If your cushion does not have a solid wood base, this cover is not compatible. When in doubt, send us photos — we'll confirm before you order.

Simple Shapes Only

Rectangle and square cushions only. We cannot accommodate curves, angles, notches, cutouts, or irregular shapes. Photos help us confirm your cushion qualifies before we commit.

Commercial-Grade Vinyl. Built to Last.

• Extra Heavy-Duty Commercial Vinyl — tough, smooth, wipe-clean
• 4 Reinforced Sewn Corners — where cheap covers fail first
• Disinfectant-Safe Surface — easy to clean between trips
• UV-Resistant — won't fade or stiffen in the sun
• Multiple Colors Available — match your RV interior
• Made in the USA — every cover, every time

DIY Staple-On Installation

Your cushion must have a wood or plywood base to staple to — seat bottoms and backrests alike. Installation is straightforward with a standard staple gun.

1. Remove old cover if needed
2. Center your new vinyl cover over the foam
3. Pull tight, wrap underneath, and staple to the wood base
4. Done — clean corners, tight fit, professional result

What You Get

One custom-made replacement vinyl cover, cut and sewn to your confirmed measurements. Foam, wood base, staples, staple gun, and hardware are not included.

Perfect For

• RV & Camper Dinette Cushions
• Motorhome Booth Seating
• Fifth-Wheel Dinette Seats
• Travel Trailer Bench Seats
• Any rectangular RV seat or backrest cushion with a wood base

Stop living with seats that embarrass you. Replace the cover — not the cushion.

👉 Get Your Custom Quote — Submit Measurements & Photos

National Seat Covers® — Commercial-Grade Vinyl. Made in the USA. Pricing confirmed per order.