Bar Stool Cover Installation Guide
Follow these steps to install your bar stool vinyl seat cover in about 30 minutes.
You'll Need
Heavy-duty staple gun • 1/4" T50 staples
1. Dry Fit First
Your cover ships inside out by design. Lay it over the seat cushion without stapling and confirm the fit. Do not cut or staple until you are satisfied with the dry fit.
2. Remove the Seat Top
Unscrew the seat top from the stool base. This makes stapling much easier and gives you a clean surface to work on.
3. Check the Old Cover
Good condition? Leave it. Install right over it.
Cracked, torn, or rough? Cut it off on the inside of the staples. It lifts right off.
4. Center the Cover
Once satisfied with the fit, center the cover with equal overhang on all sides.
5. Stretch & Staple
Stretch the cover evenly over the cushion. Center of each side first. Pull taut. Staple every 1–2". Work to the corners.
6. Reinstall Seat Top
Screw the seat top back onto the stool base. You're done.
Video Guide
[Coming soon]
Need help? Contact us — phone support available.